Missions

COSMO

Compact Spaceborne Magnetic Observatory

A magnetically clean 6U CubeSat carrying a vectorized rubidium magnetometer, built to supply precise, low-cost data for the World Magnetic Model. Launched March 30, 2026.

Why measure the field from space

Every phone compass, and much of navigation, depends on the World Magnetic Model (WMM), produced by NOAA's National Centers for Environmental Information. The model is built from ground magnetometers plus satellite data that fill the gaps in ground coverage: Ørsted, CHAMP, and now ESA's Swarm. The WMM needs about three years of good data every five years to make a reliable prediction, and its errors still grow with time. Space-based measurements are only useful if they are both precise and accurate.

COSMO's goal is to provide accurate and precise magnetic field data for the WMM at lower cost, for the foreseeable future.

Rendering of COSMO with its boom and solar panels deployed
COSMO deployed: the boom carries the magnetometer and star trackers away from the spacecraft's attitude control system and electronics.

The Vector Rubidium Magnetometer

VRuM is built around a rubidium-87 optical scalar magnetometer. A scalar magnetometer measures field strength very accurately by tracking the field-dependent energy splitting in rubidium atoms. Once locked, it can follow the field at more than 200 Hz, and it tolerates changes of up to 200 µT per second. To get the field's direction as well, we "vectorize" the scalar sensor. We apply small sinusoidal fields of known frequency, amplitude, and direction, then extract the three components of the external field from the modulated signal.

The result is all three field components at 1 Hz and the scalar magnitude at 100 Hz. Because the measurement rests on atomic physics, it is absolute and does not drift. The payload electronics run the laser and RF coils, generate the modulation signals, and collect data from two star trackers. Those trackers give pointing knowledge to within 10 arcseconds. A common optical bench keeps the magnetometer and star trackers aligned.

Rendering of the VRuM payload: magnetometer cube, star trackers, and electronics
The VRuM payload: magnetometer cube, two star trackers, and payload electronics.
The flight magnetometer cube
The flight cube is machined from Zerodur, whose thermal expansion is essentially zero (0 ± 0.1 ppm/K).
Coiled Braunbek cube
The Braunbek coil cube that applies the modulation fields.
CAD model of the cube
CAD model, adapted from Chism et al. (2025).
Cutaway view of the cube
Inside the cube, showing the two scalar sensors.

The spacecraft

The bus was developed at CU Boulder with LASP, drawing on heritage from the CTIM, CSIM, and AEPEX CubeSats, and it shares design elements with CANVAS. It uses a LASP flight computer and "Common Code" flight software, a LASP power system and battery, and CU/LASP solar panels. It also carries a Blue Canyon XACT attitude control system, SpaceQuest S-band and UHF radios, and an MMA tri-tape deployable boom. Most of the bus is flight-proven; the new technology is in the scalar sensor, the optical bench and cube, and the LASP battery.

In science mode, during eclipse, the spacecraft points along the magnetic field; in daylight it points at the Sun to charge.

COSMO during integration
Integration of the flight spacecraft.
The flight-ready COSMO spacecraft in the clean room
Flight-ready.

Testing

In May 2025 the integrated COSMO went to NASA Goddard Space Flight Center's Magnetic Test Facility, a 42 ft Braunbek coil system that can null Earth's field and apply arbitrary fields in any direction. There we ran angular calibration, linearity, stability, and precision and accuracy tests, and characterized the spacecraft's own magnetic bias. Thermal vacuum, vibration, and end-to-end testing were completed on 25 November 2025.

The Goddard magnetic test facility coil system
The 42 ft coil system at the Goddard Magnetic Test Facility.
COSMO in a thermal vacuum chamber
Thermal vacuum testing.
Histogram of COSMO vector magnitude residuals compared with an Overhauser reference
Precision test at Goddard: COSMO's vector magnitude against an Overhauser reference magnetometer, with an rms spread of 1.71 nT.

Precision and accuracy tests at Goddard compared VRuM against an Overhauser reference magnetometer over the full range of applied fields.

Launch and commissioning

COSMO launched on 30 March 2026 from Vandenberg Space Force Base on SpaceX's Transporter-16 rideshare, the same launch as AEPEX, and was deployed immediately. Commissioning began in early April. The attitude control system was commissioned in May and spacecraft avionics and software in June. The boom deployed successfully on 31 July 2026, on the first try.

COSMO on the CubeSat dispenser
COSMO on the dispenser. Credit: SpaceX.
Falcon 9 lifting off on Transporter-16
Transporter-16 lifts off, 30 March 2026.

The magnetometer has locked and recorded data, and the star trackers are reporting accurate attitude. First data came on 13 August 2026. Those early collections were taken outside science pointing, with biases not yet removed and noisy attitude components running. Even so, the measured field tracks the WMM prediction. We are still investigating intermittent difficulty getting a reliable scalar lock. Instrument commissioning is underway.

First COSMO field magnitude compared with the WMM and the XACT magnetometer
First look, 13 August 2026: field magnitude from VRuM compared with the WMM and the attitude system's magnetometer.
References and talks
  1. Chism, C. T., R. A. Marshall, A. Aguilar-Nadalini, S. Knappe, D. Malaspina, K. J. Hughes, M. Ellmeier, S. Wankmueller, C. Cunningham, T. Maydew, and O. Alem (2025), Design of a vectorized rubidium scalar magnetometer for SmallSat applications, Advances in Space Research, 76(8), 4635–4646. doi
  2. Ellmeier, M., et al. (2025), A compact vectorized magnetometer for measuring Earth's magnetic field in space, Proc. SPIE 13392, 133920A. doi
  3. Chism, C. T. (2024), Development and characterization of a miniature vectorized rubidium magnetometer for spaceborne measurements of Earth's magnetic field, Ph.D. dissertation, University of Colorado Boulder. CU Scholar
  4. Kao, T.-H., et al. (2026), In-orbit calibration of the vectorized rubidium magnetometer onboard COSMO, EGU General Assembly, Vienna.
  5. Marshall, R. A., et al. (2024), The Compact Spaceborne Magnetic Observatory: Precise measurements of the Earth's magnetic field from a 6U CubeSat platform, 45th COSPAR Scientific Assembly, Busan.

COSMO is funded by the National Geospatial-Intelligence Agency through the MagQuest program. Thanks to NASA Goddard for the use of their Magnetic Test Facility.